示波器部份
Oscilloscope |
垂直部份 |
頻寬 |
200 MHz |
頻寬限制選擇 |
User selectable 10 kHz or 20 MHz
|
輸入通道數 |
2個,完全分離模式的隔離通道 |
耦合
coupling |
AC,DCwith ground level indicator |
靈敏度
sensitivity |
5 mV/div to 100 V/div
|
輸入電壓 |
1000V CAT-II 及600V CAT-III規格 |
垂直解析度 |
8 Bits
|
精度
Accuracy |
±(1.5%
of reading + 0.04 x range/div)
|
輸入阻抗 |
1MΩ
±
1% // 15pF
±
2 pF
|
水平部份 |
最大取樣率 |
2.5GS/s
|
時基範圍 |
5 ns/div to 5 s/div
|
最大記錄長度 |
1,000 points per input
27,500 points per input in ScopeRecord - roll mode (10
ms/div ... 2 min/div)
|
精度
Accuracy |
±(1%
of reading +1 pixle)
|
Glitch capture |
50nsec(5usec to 1 min/div)
Faster time base have higher sample rates then 20 MS/s
|
顯示及擷取
Display and acquisition |
Display modes |
Input A, Input B, dual, average, persistence, invert,
replay (on/off)
|
Acquisition modes |
Normall, auto, single shot, ScopeRecord, roll, glitch
capture. (on/off) |
Waveform Mathematics |
A+B,A-B,AxB, A versus B (X-Y mode)
|
觸發及延時
Trigger and delay |
來源
Source |
Input A, Input B, external trigger input, All input
references isolated from each other and ground.
|
模式
Modes |
Automatic Connect-and-View, free run, single shot, edge,
delay, video, video line, selectable pulse width.
|
即點即測功能
Connect-and-View |
Advanced automatic triggering that recognizes signal
patterns, automatically sets up and continuously adjusts
triggering, time base and amplitude, Automatically
displays stable waveforms of complex and dynamic signals
like motor drive and control signals.
會自動設定觸發條件、振幅、時基等各項設定值。 |
視訊觸發
Video triggering |
NTSC, PAL, PAL+, SECAM includes field 1 and 2 and line
select. |
脈波寬度觸發
Pulse width triggering |
Pulse width qualified by time.
Allows for triggering <t, >t, =t,
≠t,
where t is selectable in steps of 0.01 div or 50 nsec.
|
Time delay |
9 divisions pre-trigger view to 1.000 divisions trigger
delay.
|
畫面儲存功能
Automatic capture of 100 screens |
FLUKE 190
系列會自動記錄之前所量測的100
個畫面並且存放在記憶體中(RAM),只要不關機就可以一直重覆撥放,用來檢查之前一閃即逝的波形。 |
重撥功能
Replay |
可自動或手動撥放 |
儲存
Replay storage |
最多可以儲存2
組
100
個畫面的設定及內容,且可以由示波器叫出來後再進行分析,(Zoon,
Cursor) 功能 |
自動量測
Automatic scope measurements |
FLUKE190系列可同時顯示4組在畫面,共支援:
VDC, VAC rms, VAC+DC, Vpeak ma, Vpeak min, Vpeak to
peak, frequency (Hz), positive pulse width, negative
pulse width, positive duty cycle, negative duty cycle,
amp AC, amp DC amp AC+DC, power factor, watts, VA, VA
reactive, phase, temperature
℃,
temperature ℉,
dBV, dBm into 50 Ω and 600 Ω. |
游標功能
Cursor measurement |
來源
Source |
Input A or B
|
Dual Horizontal lines (頻率) |
Voltage at cursor 1 and 2, voltage between cursors.
|
Dual Vertical lines
(電壓) |
Time between cursors, voltage between markers.
|
Single vertical line
(最大、最小值) |
Min-Max and Average voltage at cursor position.
|
放大功能
Zoom |
Up to 8X horizontal zoom.
最大可放至8
倍 |
|
電錶部份
Meter |
最大解析度 |
5,000 counts. |
電壓檔位 |
500mV, 5V, 50V, 500V, 1000V
|
精度
Accuracy |
VDC :
±(0.5% + 5 counts)
VAC true rms:
15 Hz to 60 Hz :
±(1% + 10 counts)
60Hz to 1 kHz : ±(2.5% + 15 counts)
VAC+DC true rms:
DC to 60 Hz :
±(1% + 10 counts)
60Hz to 1 kHz : ±(2.5% + 15 counts) |
電阻
Ohms |
Ranges:
500Ω,
5kΩ, 50kΩ, 500kΩ, 5MΩ, 30MΩ
Accuracy:
±(0.6% + 5 counts)
|
通斷測試 |
Beeper on < 30Ω
(± 10 Ω)
|
二極體測試 |
Up to 2.8V
|
電流 |
Amp DC, Amp AC, Amp AC+DC
此部份須選購
FLUKE
的電流勾夾等配件方可使用,且須符合規格
0.1 mV/Amp to 100V/Amp
的輸入訊號才能使用。 |
溫度量測 |
華氐及攝氐皆可量測,
此部份須選購
FLUKE
的溫度測量配件方可使用,且須符合規格
1mV/ 1度
的輸入訊號才能使用。 |
其他功能 |
自動/手動量程切換
(Auto Range)
連續式曲線記錄功能(TrendPlot)
等 |
記錄器部份
Recorder |
示波器模式記錄
ScopeRecord-roll mode |
來源
Source |
Input A, Input B, Dual
|
記錄長度 |
27,500 points per input, Each point consist of Min-Max
peir.
|
Time base range |
10ms/div to 1 min/div |
2 min/div |
Recorded timespan |
11 sec to 15 hrs |
36rs |
Glitch capture |
50 nsec |
250 nsec |
Sample rate |
20 MS/s |
4MS/s |
Resolution |
400 usec to 2sec |
4 sec |
|
記錄模式
Recording mode |
Single sweep, continuous roll, start on next external
trigger. |
時基刻度 |
Time from start, time of day
|
放大功能 |
Up to 100x Zoom
|
儲存功能
Memory |
Up to 2 dual input ScopeRecordings can be saved for
later recall and analysis.
|
曲線記錄器部份 |
來源
Source |
Input A, Input B, DMM input.
|
記錄長度 |
13,500 points record per input. and time and date stamp
are stored.
|
量程
Range |
10 s/div to 20 min/div in normall view mode
10 min/div o 24 hour/div in view-all mode (overview of
total record) |
記錄時間 |
Up to 8 days with a resolution of 1 minute. |
記錄模式 |
Continuous roll
|
量測速度 |
2.5 measurements per second maximum.
|
水平刻度 |
Time from start, time of day
|
放大功能 |
Up to 64x zoom
|
儲存 |
Up to 2 TrendPlot recordings can be saved for later
recall and analysis.
|
游標功能
Cursor measurement |
來源
Source |
Input A or B or
DMM input |
記錄器的游標功能和示波器的功能相同,能針對畫面上的波形取最大、最大、頻率、電壓等讀值 |
其他規格
General Specifications |
顯示器
Display |
彩色
LCD 130mm, 240*240 pixels.
|
電源
Power |
Line Power:
AC 110/220V 50/60 Hz
Battery :
可充電式
NiMH 電池
Battery Charge time:
4 hours
Battery operating time:
4 hours
|
機器規格 |
Size:256*169*64
mm
Weight:
1.95 kG
|
通訊介面 |
FLUKE 190
系列採用紅外線介面和電腦通訊,Cable
為選購配件 |
軟體及攜帶箱 |
此兩項為選購配件
Fluke View :
SW90W 及
C198 攜帶箱
|
|